Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 61
Enter the IP address in A.B.C.D format, GigabitEthernet, port-channel, fortyGigE
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
ipv6-address count datagram size timeout source tos df-bit outgoing-interface validate-reply pattern pattern sweep-min-size sweep-max-size (OPTIONAL) Enter the IPv6 address, in the x:x:x:x::x format, to which you are testing connectivity. Note: The :: notation specifies successive hexadecimal fields of zeros Enter the number of echo packets to be sent. number: 1- 2147483647 Continuous: transmit echo request continuously Default: 5 Enter the ICMP datagram size. Range: 100 - 15360 bytes Default: 100 Enter the interval to wait for an echo reply before timing out. Range: 0 -3600 seconds Default: 2 seconds (IPv4 only) Enter the IPv4 source ip address or the source interface. • Enter the IP address in A.B.C.D format • For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel, enter the keyword port-channel followed by a number: S-Series: 1-128 • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. (IPv4 only) Enter the type of service required. Range: 0-255 Default: 0 (IPv4 only) Enter Y or N for the "don't fragment" bit in IPv4 header N: Do not set the "don't fragment" bit Y: Do set "don't fragment" bit Default is No. (IPv6 link-local address) Enter outgoing interface for ping packets to a destination link-local address. (IPv4 only) Enter Y or N for reply validation. N: Do not validate reply data Y: Do validate reply data Default is No. (IPv4 only) Enter the IPv4 data pattern. Range: 0-FFFF Default: 0xABCD Enter the minimum size of datagram in sweep range. Range: 100-15359 bytes Enter the maximum size of datagram in sweep range. Range: 101-15360 bytes Control and Monitoring | 61