Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 586
advertise dot1-tlv, advertise dot3-tlv
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 586 highlights
www.dell.com | support.dell.com See the Link Layer Discovery Protocol chapter of the FTOS Configuration Guide for details on implementing LLDP/LLDP-MED. advertise dot1-tlv s z S6000 Advertise dot1 TLVs (Type, Length, Value). Syntax advertise dot1-tlv {port-protocol-vlan-id | port-vlan-id | vlan-name} To remove advertised dot1-tlv, use the no advertise dot1-tlv {port-protocol-vlan-id | port-vlan-id | vlan-name} command. Parameters port-protocol-vlan-id port-vlan-id vlan-name Enter the keyword port-protocol-vlan-id to advertise the port protocol VLAN identification TLV. Enter the keyword port-vlan-id to advertise the port VLAN identification TLV. Enter the keyword vlan-name to advertise the vlan-name TLV. This keyword is only supported on S-Series. Defaults Disabled Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp) Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.3.7.0 Introduced on the S6000. Introduced on Z9000 Introduced on the S-Series. Related Commands protocol lldp (Configuration) debug lldp interface show lldp neighbors show running-config lldp Enable LLDP globally. Debug LLDP Display the LLDP neighbors Display the LLDP running configuration advertise dot3-tlv s z S6000 Advertise dot3 TLVs (Type, Length, Value). Syntax advertise dot3-tlv {max-frame-size} To remove advertised dot3-tlv, use the no advertise dot3-tlv {max-frame-size} command. Parameters max-frame-size Enter the keyword max-frame-size to advertise the dot3 maximum frame size. Defaults No default values or behavior Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp) 586 | Link Layer Detection Protocol (LLDP)