Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 392

www.dell.com | support.dell.com Defaults Enabled Command Modes CONFIGURATION-GVRP Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.2.1.0 Introduced on then S6000. Introduced on the Z9000. Introduced on the S-Series Related Commands gvrp enable protocol gvrp Enable GVRP on physical interfaces and LAGs. Access GVRP protocol garp timers s z S6000 Set the intervals (in milliseconds) for sending GARP messages. Syntax garp timers {join | leave | leave-all} To return to the previous setting, use the no garp timers {join | leave | leave-all} command. Parameters join leave leave-all Enter the keyword join followed by the number of milliseconds to configure the join time. Range: 100-2147483647 milliseconds Default: 200 milliseconds Note: Designate the milliseconds in multiples of 100 Enter the keyword leave followed by the number of milliseconds to configure the leave time. Range: 100-2147483647 milliseconds Default: 600 milliseconds Note: Designate the milliseconds in multiples of 100 Enter the keyword leave-all followed by the number of milliseconds to configure the leave-all time. Range: 100-2147483647 milliseconds Default: 1000 milliseconds Note: Designate the milliseconds in multiples of 100 Defaults Default as above Command Modes CONFIGURATION-GVRP Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.2.1.0 Introduced on then S6000. Introduced on the Z9000. Introduced on the S-Series Usage Information Join Timer-Join messages announce the willingness to register some attributes with other participants. Each GARP application entity sends a Join message twice, for reliability, and uses a join timer to set the sending interval. 392 | GARP VLAN Registration (GVRP)