Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 437
rate-interval, show config
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 437 highlights
rate-interval s z S6000 Configure the traffic sampling interval on the selected interface. Syntax rate-interval seconds Parameters seconds Enter the number of seconds for which to collect traffic data. Range: 30 to 299 seconds Note: Since polling occurs every 15 seconds, the number of seconds designated here will round to the multiple of 15 seconds lower than the entered value. For example, if 44 seconds is designated it will round to 30; 45 to 59 seconds will round to 45, and so forth. Defaults Command Modes 299 seconds INTERFACE Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.2.1.0 Introduced on then S6000. Introduced on the Z9000. Introduced on the S4810 Usage Information The configured rate interval is displayed, along with the collected traffic data, in the output of show interfaces commands. Related Commands show interfaces Display information on physical and virtual interfaces. show config s z S6000 Display the interface configuration. Syntax show config Command Modes INTERFACE Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.2.1.0 Introduced on then S6000. Introduced on the Z9000. Introduced on the S4810 Example Figure 20-23. show config Command Example for the INTERFACE Mode FTOS(conf-if-fo-0/4)#show config !interface fortyGigE 0/4 no ip address mtu 12000 switchport no shutdown FTOS(conf-if-fo-0/4)# Interfaces | 437