Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 183

Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.6.1.0 Introduced on the S6000 Introduced on the Z9000. Support added for S-Series match route-type s z S6000 Configure a filter to match routes based on the how the route is defined. Syntax match route-type {external [type-1 | type-2] | internal | level-1 | level-2 | local} To delete a match, use the no match route-type {local | internal | external [type-1 | type-2] | level-1 | level-2} command. Parameters external [type-1| type-2] internal level-1 level-2 local Enter the keyword external followed by either type-1 or type-2 to match only on OSPF Type 1 routes or OSPF Type 2 routes. Enter the keyword internal to match only on routes generated within OSPF areas. Enter the keyword level-1 to match IS-IS Level 1 routes. Enter the keyword level-2 to match IS-IS Level 2 routes. Enter the keyword local to match only on routes generated within the switch. Defaults Not configured. Command Modes ROUTE-MAP Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.6.1.0 Introduced on the S6000 Introduced on the Z9000. Support added for S-Series Related Commands match interface match ip address match ip next-hop match ip route-source match metric match tag Redistribute routes that match the next-hop interface. Redistribute routes that match an IP address. Redistribute routes that match the next-hop IP address. Redistribute routes that match routes advertised by other routers. Redistribute routes that match a specific metric. Redistribute routes that match a tag. match tag s z S6000 Configure a filter to redistribute only routes that match a specified tag value. Syntax match tag tag-value To remove a match, use the no match tag command. Access Control Lists (ACL) | 183