Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 609

Defaults As above Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.3.7.0 Introduced on the S6000. Introduced on Z9000 Introduced on the S4810. Usage Information The connect-source option is used to supply a source IP address for the TCP connection. When an interface is specified using the connect-source option, the primary configured address on the interface is used. If the total number of SA messages received from the peer is already larger than the limit when this command is applied, those SA messages will continue to be accepted. To enforce the limit in such situation, use command clear ip msdp peer command to reset the peer. Related Commands ip msdp sa-limit clear ip msdp peer show ip msdp Configure the MSDP SA Limit Clear the MSDP peer. Display the MSDP information ip msdp redistribute z S6000 Filter local PIM SA entries in the SA cache. SAs which are denied by the ACL will time out and not be refreshed. Until they time out, they will continue to reside in the MSDP SA cache. Syntax ip msdp redistribute [list acl-name] Parameters list acl-name Enter the name of an extended ACL that contains permitted SAs. If you do not use this option, all local entries are blocked. Defaults Not configured Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.3.7.0 Introduced on the S6000. Introduced on Z9000 Introduced on the S4810. Usage Information Modifications to the ACL will not have an immediate affect on the sa-cache. To apply the redistribute filter to entries already present in the SA cache, use clear ip msdp sa-cache local. ip msdp sa-filter z S6000 Permit or deny MSDP source active (SA) messages based on multicast source and/or group from the specified peer. Multicast Source Discovery Protocol (MSDP) | 609