Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 775
neighbor, network
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 775 highlights
Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000 Usage RIP supports a maximum of 16 ECMP paths. Information neighbor z S6000 Define a neighbor router with which to exchange RIP information. Syntax neighbor ip-address To delete a neighbor setting, use the no neighbor ip-address command. Parameters ip-address Enter the IP address, in dotted decimal format, of a router with which to exchange information. Defaults Not configured. Command Modes ROUTER RIP Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000 Usage When a neighbor router is identified, unicast data exchanges occur. Multiple neighbor routers are Information possible. Use the passive-interface command in conjunction with the neighbor command to ensure that only specific interfaces are receiving and sending data. Related Commands passive-interface Sets the interface to only listen to RIP broadcasts. network z S6000 Enable RIP for a specified network. Use this command to enable RIP on all networks connected to the switch. Syntax network ip-address To disable RIP for a network, use the no network ip-address command. Parameter ip-address Specify an IP network address in dotted decimal format. You cannot specify a subnet. Defaults No RIP network is configured. Command Modes ROUTER RIP Router Information Protocol (RIP) | 775