Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 480
ip domain-name, ip helper-address
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 480 highlights
www.dell.com | support.dell.com FTOS does not support sending DNS queries over a VLAN. DNS queries are sent out all other interfaces, including the Management port. To view current bindings, use the show hosts command. Related Commands ip name-server show hosts Specify a DNS server. View current bindings. ip domain-name z S6000 Configure one domain name for the switch. Syntax ip domain-name name To remove the domain name, enter no ip domain-name. Parameters name Enter one domain name to be used to complete unqualified names (that is, incomplete domain names that cannot be resolved). Defaults Not configured. Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000 Usage Information You can only configure one domain name with the ip domain-name command. To configure more than one domain name, configure the ip domain-list command up to 6 times. Use the following steps to enable dynamic resolution of hosts: • specify a domain name server with the ip name-server command. • enable DNS with the ip domain-lookup command. To view current bindings, use the show hosts command. Related Commands ip domain-list Configure additional names. ip helper-address z S6000 Specify the address of a DHCP server so that DHCP broadcast messages can be forwarded when the DHCP server is not on the same subnet as the client. Syntax ip helper-address ip-address | ipv6-address | default-vrf To remove a DHCP server address, enter no ip helper-address. 480 | IPv4 Routing