Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 861
protocol-tunnel destination-mac, protocol-tunnel enable
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 861 highlights
Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.4.1.0 Introduced on the S6000. Introduced on Z9000 Introduced Example Usage Information Figure 40-1. Protocol-tunneling Command Example FTOS#conf FTOS(conf)#interface vlan 2 FTOS(conf-if-vl-2)#vlan-stack compatible FTOS(conf-if-vl-2)#member Gi1/2-3 FTOS(conf-if-vl-2)#protocol-tunnel stp FTOS(conf-if-vl-2)# Note: When VLAN-Stacking is enabled, no protocol packets are tunneled. Related Commands show protocol-tunnel Display tunneling information for all VLANs protocol-tunnel destination-mac z S6000 Overwrite the BPDU destination MAC address with a specific value. Syntax protocol-tunnel destination-mac xstp address Parameters stp Change the default destination MAC address used for L2PT to another value. Defaults The default destination MAC is 01:01:e8:00:00:00. Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.4.1.0 Introduced on the S6000. Introduced on Z9000 Introduced Usage When VLAN-Stacking is enabled, no protocol packets are tunneled. Information Related Commands show protocol-tunnel Display tunneling information for all VLANs protocol-tunnel enable z S6000 Enable protocol tunneling globally on the system. Syntax protocol-tunnel enable To disable protocol tunneling, use the no protocol-tunnel enable command. Defaults Disabled Service Provider Bridging | 861