Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 325
dcbx version, debug dcbx
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 325 highlights
Command History Usage Information Version 9.0.2.0 Version 8.3.16.0 Introduced on the S6000. Introduced on MXL 10/40GbE Switch IO Module DCBX requires that you enable LLDP to advertise DCBX TLVs to peers. Configure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the DCBX configuration on a port, use the show interface dcbx detail command. dcbx version S6000 Configure the DCBX version used on the interface. Syntax dcbx version {auto | cee | cin | ieee-v2.5} To remove the DCBX version, use the dcbx version {auto | cee | cin | ieee-v2.5} command. Parameters auto | cee | cin | ieee-v2.5 Enter the DCBX version type used on the interface, where: • auto: configures the port to operate using the DCBX version received from a peer. • cee: configures the port to use CDD (Intel 1.01). • cin: configures the port to use Cisco-Intel-Nuova (DCBX 1.0). • ieee-v2: configures the port to use IEEE 802.1az (Draft 2.5). Defaults Auto Command Modes PROTOCOL LLDP INTERFACE PROTOCOL LLDP Command History Version 9.0.2.0 Version 8.3.16.0 Introduced on the S6000. Introduced on MXL 10/40GbE Switch IO Module Usage Information DCBX requires that you enable LLDP to advertise DCBX TLVs to peers. Configure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the DCBX configuration on a port, use the show interface dcbx detail command. debug dcbx S6000 Enable DCBX debugging. Syntax debug dcbx {all | auto-detect-timer | config-exchng | fail | mgmt | resource | sem | tlv} To disable DCBX debugging, use the no debug dcbx command. Data Center Bridging (DCB) | 325