Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 610
ip msdp sa-limit
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 610 highlights
www.dell.com | support.dell.com Syntax ip msdp sa-filter {in | out} peer-address list [access-list name] Remove this configuration using the command no ip msdp sa-filter {in | out} peer address list [access-list name] Parameters in out peer-address access-list name Enter the keyword in to enable incoming SA filtering. Enter the keyword out to enable outgoing SA filtering. Enter the peer address of the MSDP peer in a dotted decimal format (A.B.C.D.) (OPTIONAL) Enter the IP extended access list name that defines from which peers SAs are to be permitted or denied. Defaults Not configured Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.3.7.0 Introduced on the S6000. Introduced on Z9000 Introduced on the S4810. ip msdp sa-limit z S6000 Configure the upper limit of SA (Source-Active) entries in SA-cache. Syntax ip msdp sa-limit number To return to the default, use the no ip msdp sa-limit number command. Parameters number Enter the maximum number of SA entries in SA-cache. Range 0 to 40000 Defaults Default 50000 Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.3.7.0 Introduced on the S6000. Introduced on Z9000 Introduced on the S4810. Usage Information FTOS counts the SA messages originated by itself and those received from the MSDP peers. When the total SA messages reach this limit, the subsequent SA messages are dropped (even if they pass RPF checking and policy checking). If the total number of SA messages is already larger than the limit when this command is applied, those SA messages that are already in FTOS will continue to be accepted. To enforce the limit in such situation, use the clear ip msdp sa-cache command. 610 | Multicast Source Discovery Protocol (MSDP)