Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 420
flowcontrol - user manual
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 420 highlights
www.dell.com | support.dell.com Version 8.3.11.1 Version 8.2.1.0 Introduced on the Z9000. Introduced on the S4810 Usage Information This command applies only to the Management interface. When manually configuring the management port speed the user must consider and match the remote device. It is highly recommended to use Auto-Negotiation for management ports. Related Commands interface ManagementEthernet duplex (Management) management route speed (Management interface) Configure the Management port on the system (either the Primary or Standby RPM). Set the mode of the Management interface. Configure a static route that points to the Management interface or a forwarding router. Set the speed on the Management interface. flowcontrol s z S6000 Control how the system responds to and generates 802.3x pause frames on 1Gig and 10Gig, 40Gig, ports. Syntax flowcontrol rx {off | on} tx {off | on} [pause- threshold {] [resume-offset } The threshold commands are supported on S-Series only. To return to the default, use the no flowcontrol rx {off | on} tx {off | on} threshold command. Parameters rx on rx off tx on tx off pause-thresh old resume-offse t Enter the keywords rx on to process the received flow control frames on this port. This is the default value for the receive side. Enter the keywords rx off to ignore the received flow control frames on this port. Enter the keywords tx on to send control frames from this port to the connected device when a higher rate of traffic is received. This is the default value on the send side. Enter the keywords tx off so that flow control frames are not sent from this port to the connected device when a higher rate of traffic is received. Enter the buffer threshold limit for generating PAUSE frames. Enter the offset value for generating PAUSE frames to resume traffic. Defaults S6000: rx off tx off S4810:rx on tx off pause-threshold: 59 KB resume-offset: 9 KB Command Modes INTERFACE 420 | Interfaces