Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 532

www.dell.com | support.dell.com Usage Information IS-IS normally purges LSPs with an incorrect data link checksum, causing the LSP source to regenerate the message. A cycle of purging and regenerating LSPs can occur when a network link continues to deliver accurate LSPs even though there is a link causing data corruption. This could cause disruption to your system operation. ip router isis S6000 Configure IS-IS routing processes on an interface and attach an area tag name to the routing process. Syntax ip router isis [tag] To disable IS-IS on an interface, enter the no ip router isis [tag] command. Parameters tag (OPTIONAL) The tag you specify identifies a specific area routing process. If you do not specify a tag, a null tag is assigned. Defaults No processes are configured. Command Modes INTERFACE Command History Version 9.0.2.0 Version 8.3.7.0 Introduced on the S6000. Introduced on the S4810. Usage You must use the net command to assign a network entity title to enable IS-IS. Information Related Commands net router isis Configures an IS-IS network entity title (NET) for the routing process. Enables the IS-IS routing protocol. ipv6 router isis z S6000 Enable the IPv6 IS-IS routing protocol and specify an IPv6 IS-IS process. Syntax ipv6 router isis [tag] To disable IS-IS routing, enter no router isis [tag]. Parameters tag (OPTIONAL) This is a unique name for a routing process. A null tag is assumed if the tag option is not specified. The tag name must be unique for all IP router processes for a given router. Defaults Not configured. Command Modes ROUTER ISIS Command History Version 9.0.2.0 Introduced on the S6000. 532 |