Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 590
Related, Commands, Syntax, Parameters, Defaults, Command Modes, History, To return to the default
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 590 highlights
www.dell.com | support.dell.com Related Commands protocol lldp (Configuration) debug lldp interface show lldp neighbors show running-config lldp Enable LLDP globally. Debug LLDP Display the LLDP neighbors Display the LLDP running configuration hello s z S6000 Configure the rate at which the LLDP control packets are sent to its peer. Syntax hello seconds To revert to the default, use the no hello seconds command. Parameters seconds Enter the rate, in seconds, at which the control packets are sent to its peer. Rate: 5 - 180 seconds Default: 30 seconds Defaults 30 seconds Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp) Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.3.7.0 Introduced on the S6000. Introduced on Z9000 Introduced on the S-Series. mode s z S6000 Set LLDP to receive or transmit. Syntax mode {tx | rx} To return to the default, use the no mode {tx | rx} command. Parameters tx rx Enter the keyword tx to set the mode to transmit. Enter the keyword rx to set the mode to receive. Defaults Both transmit and receive Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp) Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.3.7.0 Introduced on the S6000. Introduced on Z9000 Introduced on the S-Series. 590 | Link Layer Detection Protocol (LLDP)