Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 693
ip pim join-filter, ip pim neighbor-filter
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 693 highlights
Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.3.7.0 Introduced on the S6000. Introduced on Z9000 Introduced on the S4810. Usage Information The router with the largest value assigned to an interface becomes the Designated Router. If two interfaces contain the same DR priority value, the interface with the largest interface IP address becomes the Designated Router. ip pim join-filter s z S6000 Permit or deny PIM Join/Prune messages on an interface using an extended IP access list. This command prevents the PIM SM router from creating state based on multicast source and/or group. Syntax ip pim join-filter ext-access-list {in | out} Remove the access list using the command no ip pim join-filter ext-access-list {in | out} Parameters ext-access-list in out Enter the name of an extended access list. Enter this keyword to apply the access list to inbound traffic. Enter this keyword to apply the access list to outbound traffic. Defaults None Command Modes INTERFACE Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.3.7.0 Introduced on the S6000. Introduced on Z9000 Introduced on the S4810. Example Related Commands Figure 30-1. ip pim join-filter Command Example FTOS(conf)# ip access-list extended iptv-channels FTOS(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24 FTOS(config-ext-nacl)# permit ip any 232.1.1.0/24 FTOS(config-ext-nacl)# permit ip 100.1.1.0/16 any FTOS(config-if-gi-1/1)# ip pim join-filter iptv-channels in FTOS(config-if-gi-1/1)# ip pim join-filter iptv-channels out ip access-list extended Configure an access list based on IP addresses or protocols. ip pim neighbor-filter s z S6000 Configure this feature to prevent a router from participating in protocol independent Multicast (PIM). Syntax ip pim neighbor-filter {access-list} To remove the restriction, use the no ip pim neighbor-filter {access-list} command. PIM-Sparse Mode (PIM-SM) | 693