Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 192
set weight, show config, show route-map
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 192 highlights
www.dell.com | support.dell.com set weight s z S6000 Configure a filter to add a non-RFC compliant attribute to the BGP route to assist with route selection. Syntax set weight weight To delete a weight specification, use the no set weight weight command. Parameters weight Enter a number as the weight to be used by the route meeting the route map specification. Routes with a higher weight are preferred when there are multiple routes to the same destination. Range: 0 to 65535 Default: router-originated = 32768; all other routes = 0 Defaults router-originated = 32768; all other routes = 0 Command Modes ROUTE-MAP Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.6.1.0 Introduced on the S6000 Introduced on the Z9000. Support added for S-Series Usage If you do not use the set weight command, router-originated paths have a weight attribute of 32768 Information and all other paths have a weight attribute of zero. show config s z S6000 Display the current route map configuration. Syntax show config Command Modes ROUTE-MAP Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.6.1.0 Introduced on the S6000 Introduced on the Z9000. Support added for S-Series Example Figure 6-22. Command Example: show config FTOS(config-route-map)#show config ! route-map hopper permit 10 FTOS(config-route-map)# show route-map s z S6000 Display the current route map configurations. Syntax show route-map [map-name] 192 | Access Control Lists (ACL)