Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 580
Far-End Failure Detection (FEFD), Commands, debug fefd
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 580 highlights
www.dell.com | support.dell.com Far-End Failure Detection (FEFD) FTOS supports Far-End Failure Detection (FEFD) on the Ethernet interfaces of the following platforms as indicated by the characters that appear under each of the command headings: S6000 S6000 ,S4810 , Z-Series z The FEFD feature detects and reports far-end link failures. • FEFD is not supported on the Management interface. • During an RPM failover, FEFD is operationally disabled for approximately 8-10 seconds. • By default, FEFD is disabled. Commands The FEFD commands are: • debug fefd • fefd • fefd-global • fefd reset • show fefd debug fefd z S6000 Enable debugging of FEFD. Syntax debug fefd {events | packets} [interface] To disable debugging of FEFD, use the no debug fefd {events | packets} [interface] command. Parameters events packets interface Enter the keyword events to enable debugging of FEFD state changes. Enter the keyword packets to enable debugging of FEFD to view information on packets sent and received. (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/ port information. Command Modes EXEC Privilege 580 | Layer 2