Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 695

ip pim register-filter s z S6000 Use this feature to prevent a PIM source DR from sending register packets to an RP for the specified multicast source and group. Syntax ip pim register-filter access-list To return to the default, use the no ip pim register-filter access-list command. Parameters access-list Enter the name of an extended access list. Maximum 16 characters. Defaults Not configured Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.3.7.0 Introduced on the S6000. Introduced on Z9000 Introduced on the S4810. Usage The access name is an extended IP access list that denies PIM register packets to RP at the source DR Information based on the multicast and group addresses. Do not enter this command before creating the access-list. ip pim rp-address s z S6000 Configure a static PIM Rendezvous Point (RP) address for a group or access-list. Syntax ip pim rp-address address {group-address group-address mask} override To remove an RP address, use the no ip pim rp-address address {group-address group-address mask} override command. Parameters address group-address group-address mask override Enter the RP address in dotted decimal format (A.B.C.D). Enter the keyword group-address followed by a group-address mask, in dotted decimal format (/xx), to assign that group address to the RP. Enter the keyword override to override the BSR updates with static RP. The override will take effect immediately during enable/disable. Note: This option is applicable to multicast group range. Defaults Not configured Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.3.7.0 Introduced on the S6000. Introduced on Z9000 Introduced on the S4810. PIM-Sparse Mode (PIM-SM) | 695