Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 877

!------command run on server connected to switch snmpwalk -c public 10.10.10.130 .1.3.6.1.2.1.31 | grep -i alias | more IF-MIB::ifAlias.134530304 = STRING: This is a port connected to Router2. This is a port connected to Router2. This is a port connected to Router2. This is a port connected to Router2. This is a port connected to Router2. IF-MIB::ifAlias.134792448 = STRING: FTOS#config snmp-server community s z S6000 Configure a new community string access for SNMPv1, v2, and v3. Syntax snmp-server community community-name {ro | rw} [ipv6 ipv6-access-list-name [ipv6 ipv6-access-list-name | access-list-name | security-name name] | security-name name [ipv6 ipv6-access-list-name | access-list-name | security-name name] | access-list-name [ipv6 ipv6-access-list-name | access-list-name | security-name name]]] To remove access to a community, use the no snmp-server community community-string {ro | rw} [security-name name [access-list-name | ipv6 access-list-name | access-list-name ipv6 access-list-name]] command. Parameters community-name ro rw ipv6 access-list-name security-name name access-list-name Enter a text string (up to 20 characters long) to act as a password for SNMP. Enter the keyword ro to specify read-only permission. Enter the keyword rw to specify read-write permission. (Optional) Enter the keyword ipv6 followed by a an IPv6 ACL name (a string up to 16 characters long). (Optional) Enter the keyword security-name followed by the security name as defined by the community MIB. (Optional) Enter a standard IPv4 access list name (a string up to 16 characters long). Defaults No default behavior or values Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.6.1.0 Introduced on the S6000. Introduced on Z9000 Support added for S-Series Usage The example below configures a community named public that is mapped to the security named Information guestuser with Read Only (ro) permissions. Example Figure 42-6. snmp-server community Command Example FTOS#config FTOS(conf)# snmp-server community public ro FTOS(conf)# snmp-server community guest ro security-name guestuser FTOS(conf)# The security-name parameter maps the community string to an SNMPv3 user/security name as defined by the community MIB. Simple Network Management Protocol and Syslog | 877