Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 214

www.dell.com | support.dell.com bgp add-path Z S6000 Allow the advertisement of multiple paths for the same address prefix without the new paths replacing any previous ones. Syntax bgp add-path [send | receive | both] path-count Parameters send receive both path-count Enter this keyword to indicate that the system will send multiple paths to peers. Enter this keyword to indicate that the system will accept multiple paths from peers. Enter this keyword to indicate that the system will send and accept multiple paths from peers. Enter the number paths supported. Range: 2 - 64 Defaults Disabled Command Modes ROUTER BGP ROUTER BGP-address-family Related Commands neighbor add-path Specify that this neighbor/peer group can send/receive multiple path advertisements. Command History . Version 9.0.2.0 Version 8.3.11.0 Version 8.3.8.0 Introduced on the S6000. Introduced on the Z9000. Introduced on the S4810. bgp always-compare-med s z S6000 Enables you to enable comparison of the MULTI_EXIT_DISC (MED) attributes in the paths from different external ASs. Syntax bgp always-compare-med To disable comparison of MED, enter no bgp always-compare-med. Defaults Disabled (that is, the software only compares MEDs from neighbors within the same AS). Command Modes ROUTER BGP Usage Information Any update without a MED attribute is the least preferred route If you enable this command, use the clear ip bgp * command to recompute the best path. Command History . Version 9.0.2.0 Version 8.3.11.0 Version 8.3.8.0 Introduced on the S6000. Introduced on the Z9000. Introduced on the S4810. 214 | Border Gateway Protocol