Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 777

Syntax output-delay delay To return to the switch software defaults for interpacket delay, enter no output-delay. Parameters delay Specify a number of milliseconds as the delay interval. Range: 8 to 50 Default Not configured. Command Modes ROUTER RIP Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000 Usage This command is intended for low-speed interfaces. Information passive-interface z S6000 Suppress routing updates on a specified interface. Syntax passive-interface interface To delete a passive interface, use the no passive-interface interface command. Parameters interface Enter the following information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel, enter the keyword port-channel followed by a number from 1 to 32 for EtherScale, 1 to 255 for TeraScale, 1-128 on S-Series. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. Defaults Not configured. Command Modes ROUTER RIP Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000 Usage Although the passive interface will neither send nor receive routing updates, the network on that Information interface will still be included in RIP updates sent via other interfaces. Related Commands neighbor network Enable RIP for a specified network. Define a neighbor. Router Information Protocol (RIP) | 777