Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 657
mib-binding, network area
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 657 highlights
Command Modes ROUTER OSPF Command History Version 9.0.2.0 Version 8.3.11.1 Version 9.0.0.0 Version 7.8.1.0 Introduced on S6000. Introduced on Z9000 Range for parameter was increased from 16 to 32. Introduced support for Multi-Process OSPF. mib-binding z S6000 Enable this OSPF process ID to manage the SNMP traps and process SNMP queries. Syntax mib-binding To mib-binding on this OSPF process, enter no mib-binding. Defaults None. Command Modes ROUTER OSPF Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.8.1.0 Introduced on S6000 Introduced on Z9000 Introduced to all platforms. Usage This command is either enabled or disabled. If no OSPF process is identified as the MIB manager, the Information first OSPF process will be used. If an OSPF process has been selected, it must be disabled prior to assigning new process ID the MIB responsibility. network area z S6000 Define which interfaces run OSPF and the OSPF area for those interfaces. Syntax network ip-address mask area area-id To disable an OSPF area, use the no network ip-address mask area area-id command. Parameters ip-address mask area-id Specify a primary or secondary address in dotted decimal format. The primary address is required before adding the secondary address. Enter a network mask in /prefix format. (/x) Enter the OSPF area ID as either a decimal value or in a valid IP address. Decimal value range: 0 to 65535 IP address format: dotted decimal format A.B.C.D. Note: If the area ID is smaller than 65535, it will be converted to a decimal value. For example, if you use an area ID of 0.0.0.1, it will be converted to 1. Command Modes ROUTER OSPF Open Shortest Path First (OSPFv2) | 657