Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 177

Parameters sequence-number (OPTIONAL) Enter the route map sequence number. Range: 1 - 65535 Default: no sequence number Defaults Not Configured Command Modes ROUTE-MAP Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.6.1.0 Version 7.4.1.0 Introduced on the S6000 Introduced on the Z9000. Support added for S-Series Introduced Usage Information The continue feature allows movement from one route-map entry to a specific route-map entry (the sequence number). If the sequence number is not specified, the continue feature simply moves to the next sequence number (also known as an implied continue). If a match clause exists, the continue feature executes only after a successful match occurs. If there are no successful matches, continue is ignored. Match clause with Continue clause The continue feature can exist without a match clause. A continue clause without a match clause executes and jumps to the specified route-map entry. With a match clause and a continue clause, the match clause executes first and the continue clause next in a specified route map entry. The continue clause launches only after a successful match. The behavior is: • A successful match with a continue clause-the route map executes the set clauses and then goes to the specified route map entry upon execution of the continue clause. • If the next route map entry contains a continue clause, the route map will execute the continue clause if a successful match occurs. • If the next route map entry does not contain a continue clause, the route map evaluates normally. If a match does not does not occur, the route map does not continue and will fall through to the next sequence number, if one exists. Set clause with Continue clause If the route-map entry contains sets with the continue clause, then set actions is performed first followed by the continue clause jump to the specified route map entry. Related Commands • If a set actions occurs in the first route map entry and then the same set action occurs with a different value in a subsequent route map entry, the last set of actions overrides the previous set of actions with the same set command. • If set community additive and set as-path prepend are configure, the communities and AS numbers are pre-pended. set community set as-path Specify a COMMUNITY attribute Configure a filter to modify the AS path Access Control Lists (ACL) | 177