Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 556

www.dell.com | support.dell.com detail interface (OPTIONAL) Displays detailed information about neighbors. (OPTIONAL) Identifies the interface type slot/port as one of the following: • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel, enter the keyword port-channel followed by a number from 1 to 32 for EtherScale, 1 to 255 for TeraScale. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Command Modes EXEC EXEC privilege Command History Version 9.0.2.0 Version 8.3.8.0 Introduced on the S6000. Introduced for the S4810 Example Figure 23-8. Command Example: show isis neighbors FTOS#show isis neighbors System Id Interface State Type Priority Uptime Circuit Id TEST Gi 7/1 Up L1L2(M) 127 09:28:01 TEST.02 ! FTOS#show isis neighbors detail System Id Interface State Type Priority Uptime Circuit Id TEST Gi 7/1 Up Address(es): 49.0000.0001 L1L2(M) 127 09:28:04 TEST.02 Area IP Address(es): 25.1.1.3* MAC Address: 0000.0000.0000 Hold Time: 28 Link Local Address: fe80::201:e8ff:fe00:492c Topology: IPv4 IPv6 , Common (IPv4 IPv6 ) IPv6 Adjacency being used for MTs: IPv4 Identified Multi-Topology ISIS enabled Force 10# Table 23-3. show isis neighbors Command Example Fields Field System Id Interface State Type Priority Uptime Circuit Id Description The value that identifies a system in an area. The interface, slot, and port in which the router was discovered. The value providing status about the adjacency state. The valid values are Up and Init. This value displays the adjacency type (Layer 2, Layer 2 or both), and . IS-IS priority advertised by the neighbor. The neighbor with highest priority becomes the designated router for the interface. Displays the interfaces uptime. The neighbor's interpretation of the designated router for the interface. Usage Information Use this command to confirm that the neighbor adjacencies are operating correctly. If you suspect that they are not, you can verify the specified area addresses of the routers by using the show isis neighbors command. 556 |