Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 889
Syslog Commands, snmp trap link-status
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 889 highlights
snmp trap link-status s z S6000 Enable the interface to send SNMP link traps, which indicate whether the interface is up or down. Syntax snmp trap link-status To disable sending link trap messages, enter no snmp trap link-status. Defaults Enabled. Command Modes INTERFACE Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.6.1.0 Introduced on the S6000. Introduced on Z9000 Support added for S-Series Usage If the interface is expected to flap during normal usage, you could disable this command. Information Syslog Commands The following commands allow you to configure logging functions on all Dell Networking switches: • clear logging • default logging buffered • default logging console • default logging monitor • default logging trap • logging • logging coredump • logging buffered • logging console • logging facility • logging history • logging history size • logging monitor • logging on • logging source-interface • logging synchronous • logging trap • show logging • show logging driverlog stack-unit (S-Series) • terminal monitor Simple Network Management Protocol and Syslog | 889