Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 868
sflow extended-switch enable, sflow polling-interval Global
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 868 highlights
www.dell.com | support.dell.com Command Modes INTERFACE Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.7.1.0 Introduced on S6000 Introduced on Z9000 Introduces on S-Series Stacking Usage Information When sFlow is enable on an interface, flow sampling is done on any traffic going out of the interface. Note: Once a physical port is a member of a LAG, it will inherit the sFlow configuration from the LAG port. Related Commands sflow enable (Global) Turn sFlow on globally sflow extended-switch enable s z S6000 Enable packing information on a switch only. Syntax sflow extended-switch enable To disable packing information, use the no sflow extended-switch [enable] command. Parameters enable Enter the keyword enable to enable global extended information. Defaults Disabled Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.7.1.0 Introduced on S6000 Introduced on Z9000 Introduces on S-Series Stacking Usage Information FTOS 9.0.2.0 and later enhances the sFlow implementation for real time traffic analysis to provide extended gateway information in cases where the destination IP addresses are learned by different routing protocols, and for cases where the destination is reachable over ECMP. Related Commands sflow extended-switch enable show sflow Enable packing information on an extended gateway. Display the sFlow configuration sflow polling-interval (Global) s z S6000 Set the sFlow polling interval at a global level. Syntax sflow polling-interval interval value To return to the default, use the no sflow polling-interval interval command. 868 | sFlow