Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 378
ip ecmp-group, ip ecmp maximum-path
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 378 highlights
www.dell.com | support.dell.com Related Commands load-balance hg Change the traffic balancing method. ip ecmp-group z S6000 Enable and specify the maximum number of ecmp that the L3 CAM hold for a route, By default, when maximum paths are not configured, the CAM can hold a maximum of 16 ecmp per route. Syntax ip ecmp-group {maximum-paths | {number} {path-fallback} To negate a command, use the no command. For example no ip ecmp-group maximum-paths {number} Parameters maximum-paths path-fallback Specify the maximum number of ecmp for a route. Range: 2 to 64 Use the keyword path-fallback to enable this feature. If the feature is enabled, re-enter this keyword to disable the feature. Defaults 16 Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.2.1.0 Introduced on then S6000. Introduced on the Z9000. Introduced on the S-Series Usage Information You must save the new ECMP settings to the startup-config (write-mem) then reload the system for the new settings to take effect. Related Commands show ip cam stack-unit Display content-addressable memory (CAM) entries for an S-Series switch. ip ecmp maximum-path Z S6000 Configure the maximum number of paths used by ECMP. Syntax ip ecmp maximum-path path-number Parameters path-number Specify the maximum number paths available for use by ECMP. Range: 2 to 64 Default: 16 Defaults 16 Command Modes CONFIGURATION 378 | Equal Cost Multi-Path