Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 139

Usage Information The order option is relevant in the context of the Policy QoS feature only. The following applies: • The seq sequence-number is applicable only in an ACL group. • The order option works across ACL groups that have been applied on an interface via QoS policy framework. • The order option takes precedence over the seq sequence-number. • If sequence-number is not configured, then rules with the same order value are ordered according to their configuration order. • If the sequence-number is configured, then the sequence-number is used as a tie breaker for rules with the same order. If the sequence-number is configured, then the sequence-number is used as a tie breaker for rules with the same order. Note: When ACL logging and byte counters are configured simultaneously, byte counters may display an incorrect value. Configure packet counters with logging instead. Related Commands deny permit Configure a filter to drop packets. Configure a filter to forward packets. Common MAC Access List Commands The following commands are available within both MAC ACL modes (Standard and Extended) and do not have mode-specific options. s platforms (except the S4810) support Ingress MAC ACLs only. The S6000 and Z9000 support both Ingress and Egress MAC ACLs. The following commands allow you to clear, display and assign MAC ACL configurations. • clear counters mac access-group • mac access-group • show mac accounting access-list clear counters mac access-group s z S6000 Clear counters for all or a specific MAC ACL. Syntax clear counters mac access-group [mac-list-name] Parameters mac-list-name (OPTIONAL) Enter the name of a configured MAC access list. Command Modes EXEC Privilege Command History Version 9.0.2.0 Version 8.3.11.1 Version 9.0.2.0 Introduced on the S6000 Introduced on the Z9000. Support added for S-Series Access Control Lists (ACL) | 139