Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 267

The show ip bgp community-list command without any parameters lists BGP routes matching the Community List and the output is the same as for the show ip bgp command output. Table 9-4. show ip bgp community-list Command Example Fields Field Network Next Hop Metric LocPrf Weight Path Description Displays the destination network prefix of each BGP route. Displays the next hop address of the BGP router. If 0.0.0.0 is listed in this column, then local routes exist in the routing table. Displays the BGP route's metric, if assigned. Displays the BGP LOCAL_PREF attribute for the route. Displays the route's weight Lists all the ASs the route passed through to reach the destination network. Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.8.1.0 Introduced on the S6000. Introduced on the Z9000. Introduced support on S-Series show ip bgp dampened-paths s z S6000 View BGP routes that are dampened (non-active). Syntax show ip bgp [ipv4 unicast] dampened-paths Command Modes EXEC EXEC Privilege Example Figure 9-10. Command Example: show ip bgp dampened-paths FTOS>show ip bgp damp BGP table version is 210708, local router ID is 63.114.8.2 Status codes: s suppressed, d damped, h history, * valid, > best Path source: I - internal, a - aggregate, c - confed-external, r redistributed, n - network Origin codes: i - IGP, e - EGP, ? - incomplete Network From Reuse Path FTOS> Table 9-5 defines the information displayed in Figure 9-10. Table 9-5. show ip bgp dampened-paths Command Example Field Network From Reuse Path Description Displays the network ID to which the route is dampened. Displays the IP address of the neighbor advertising the dampened route. Displays the hour:minutes:seconds until the dampened route is available. Lists all the ASs the dampened route passed through to reach the destination network. Border Gateway Protocol | 267