Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 543
max-lsp-lifetime, maximum-paths
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 543 highlights
max-lsp-lifetime S6000 Set the maximum time that link-state packets (LSPs) exist without being refreshed. Syntax max-lsp-lifetime seconds To restore the default time, enter no max-lsp-lifetime. Parameters seconds The maximum lifetime of LSP in seconds. This value must be greater than the lsp-refresh-interval. The higher the value the longer the LSPs are kept. Range: 1 to 65535 Default: 1200 Defaults 1200 seconds Command Modes ROUTER ISIS Command History Version 9.0.2.0 Version 8.3.7.0 Introduced on the S6000. Introduced on the S4810. Usage Change the maximum LSP lifetime with this command. The maximum LSP lifetime must always be Information greater than the LSP refresh interval. The seconds parameter enables the router to keep LSPs for the specified length of time. If the value is higher, the overhead is reduced on slower-speed links. Related Commands lsp-refresh-interval Use this command to set the link-state packet (LSP) refresh interval. maximum-paths S6000 Allows you to configure the maximum number of equal cost paths allowed in a routing table. Syntax maximum-paths number To return to the default values, enter no maximum-paths. Parameters number Enter a number as the maximum number of parallel paths an IP routing installs in a routing table. Range: 1 to 32. Default: 4 Defaults 4 Command Mode ROUTER ISIS (for IPv4) CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6) | 543