Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 542
max-area-addresses
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 542 highlights
www.dell.com | support.dell.com Parameters seconds The LSP refresh interval, in seconds. This value has to be less than the seconds value specified with the max-lsp-lifetime command. Range: 1 to 65535 seconds. Default: 900 Defaults 900 seconds Command Modes ROUTER ISIS Command History Version 9.0.2.0 Version 8.3.7.0 Introduced on the S6000. Introduced on the S4810. Usage The refresh interval determines the rate at which route topology information is transmitted preventing Information the information from becoming obsolete. The refresh interval must be less than the LSP lifetime specified with the max-lsp-lifetime command. A low value reduces the amount of time that undetected link state database corruption can persist at the cost of increased link utilization. A higher value reduces the link utilization caused by the flooding of refreshed packets. Related Commands max-lsp-lifetime Sets the maximum interval that LSPs persist without being refreshed max-area-addresses S6000 Configure manual area addresses. Syntax max-area-addresses number To return to the default values, enter no max-area-addresses. Parameters number Set the maximum number of manual area addresses. Range: 3 to 6. Default: 3 Defaults 3 addresses Command Modes ROUTER ISIS Command History Version 9.0.2.0 Version 8.3.7.0 Introduced on the S6000. Introduced on the S4810. Usage Information Use this command to configure the number of area addresses on router. This value should be consistent with routers in the same area, or else, the router will form only Level 2 adjacencies. The value should be same among all the routers to form Level 1 adjacencies. 542 |