Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 903
Storm Control, Overview, Commands, Important Points to Remember
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 903 highlights
43 Storm Control Overview The FTOS Storm Control feature allows users to limit or suppress traffic during a traffic storm (Broadcast/Unknown Unicast Rate Limiting, or Multicast on the S-Series). The symbols s z under command headings indicate which Dell Networking - S6000 , S-Series or Z-Series, respectively - support the command. Commands The Storm Control commands are: • show storm-control broadcast • show storm-control multicast • show storm-control unknown-unicast • storm-control broadcast (Configuration) • storm-control broadcast (Interface) • storm-control multicast (Configuration) • storm-control multicast (Interface) • storm-control unknown-unicast (Configuration) • storm-control unknown-unicast (Interface) Important Points to Remember • Interface commands can only be applied on physical interfaces (VLANs and LAG interfaces are not supported). • An INTERFACE-level command only support storm control configuration on ingress. • An INTERFACE-level command overrides any CONFIGURATION-level ingress command for that physical interface, if both are configured. • The CONFIGURATION-level storm control commands can be applied at ingress or egress and are supported on all physical interfaces. • When storm control is applied on an interface, the percentage of storm control applied is calculated based on the advertised rate of the stack-unit. It is not based on the speed setting for the stack-unit. • Do not apply per-VLAN QoS on an interface that has storm control enabled (either on an interface or globally). Storm Control | 903