Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 195
Boot Command Line Interface (BCLI), Overview, Commands
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 195 highlights
7 Boot Command Line Interface (BCLI) Overview All commands in this chapter are in BOOT_USER mode. These commands are supported on the Dell Networking platform. To access BOOT_USER mode, first boot your Dell Networking platform.When you see the "Press ESC to stop auto-boot", press ESC to log into BCLI. You enter BOOT_USER mode immediately, as indicated by the BOOT_USER# prompt Commands • boot change • boot message • boot zero • boot show net config retries • boot write net config retries • default-gateway • ignore enable-password • ignore startup-config • interface management ethernet ip address • reload • show bootvar • show default-gateway • show interface management ethernet • serial console • show serial console baud rate • etheraddr • NVRAM erase • watchdog Note: You cannot use the Tab key to complete commands in this mode. Boot Command Line Interface (BCLI) | 195