Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 473

Related Commands ip route show ip route show ip route summary Assign an IP route to the switch. View the routing table. View a summary of the routing table. clear tcp statistics z S6000 Clear TCP counters. Syntax clear tcp statistics [all | cp | rp1 | rp2] Parameters all Enter the keyword all to clear all TCP statistics maintained on all switch processors. cp (OPTIONAL) Enter the cp to clear only statistics from the Control Processor. rp1 (OPTIONAL) Enter the keyword rp1 to clear only the statistics from Route Processor 1. rp2 (OPTIONAL) Enter the keyword rp2 to clear only the statistics from Route Processor 2. Command Modes EXEC Privilege Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000 debug arp z S6000 View information on ARP transactions. Syntax debug arp [interface] [count value] To stop debugging ARP transactions, enter no debug arp. Parameters interface count value (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword gigabitethernet followed by the slot/port information. • For the Management interface, enter the keyword managementethernet followed by the slot/port information. The slot range is 0-1 and the port range is 0. • For a Port Channel interface, enter the keyword port-channel followed by a number: S-Series Range: 1-128 • For a 10-Gigabit Ethernet interface, enter the keyword tengigabitethernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. (OPTIONAL) Enter the keyword count followed by the count value. Range: 1 to 65534 Command Modes EXEC Privilege IPv4 Routing | 473