Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 885
snmp-server packetsize, snmp-server trap-source, snmp-server, packetsize
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 885 highlights
Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.6.1.0 Introduced on the S6000. Introduced on Z9000 Support added for S-Series snmp-server packetsize s z S6000 Set the largest SNMP packet size permitted when the SNMP server is receiving a request or generating a reply, use the snmp-server packetsize global configuration command. Syntax snmp-server packetsize byte-count Parameters byte-count Enter one of the following values 8, 16, 24 or 32. Packet sizes are 8000 bytes, 16000 bytes, 32000 bytes, and 64000 bytes. Defaults 8 Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.6.1.0 Introduced on the S6000. Introduced on Z9000 Support added for S-Series snmp-server trap-source s z S6000 Configure a specific interface as the source for SNMP traffic. Syntax snmp-server trap-source interface To disable sending traps out a specific interface, enter no snmp trap-source. Parameter interface Enter the following keywords and slot/port or number information: • For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Loopback interface, enter the keyword loopback followed by a number from 0 to 16383. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. Defaults The IP address assigned to the management interface is the default. Command Modes CONFIGURATION Command History Version 9.0.2.0 Introduced on the S6000. Simple Network Management Protocol and Syslog | 885