Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 401

Parameters group-address interface (OPTIONAL) Enter the IP multicast group address in dotted decimal format. (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword gigabitethernet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword tengigabitethernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For a port-channel interface, enter the keyword port-channel followed by port-channel number. Defaults Command Modes Command History Disabled EXEC Privilege Version 9.0.2.0 Version 8.3.11.1 Introduced on then S6000. Introduced on the Z9000. Usage IGMP commands accept only non-VLAN interfaces-specifying VLAN will not yield a results. This Information command displays packets for IGMP and IGMP Snooping. Note: The S6000 supports up to 95 interfaces. ip igmp access-group z S6000 Use this feature to specify access control for packets. Syntax ip igmp access-group access-list To remove the feature, use the no ip igmp access-group access-list command. Parameters access-list Enter the name of the extended ACL (139 characters maximum). Defaults Not configured Command Modes INTERFACE (conf-if-interface-slot/port) Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on then S6000. Introduced on the Z9000. Usage The access list accepted is an extended ACL. This feature is used to block IGMP reports from hosts, on Information a per-interface basis; based on the group address and source address specified in the access list. ip igmp group-join-limit z S6000 Use this feature to limit the number of IGMP groups that can be joined in a second. Syntax ip igmp group-join-limit number Internet Group Management Protocol (IGMP) | 401