Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 163

Command History Version 9.0.2.0 Version 8.3.7.0 Introduced on the S6000. Introduced on the S4810. Usage You can assign an IPv6 access group to a physical, LAG, or VLAN interface context. Information Example Figure 6-13. Command Example: ipv6 access-group FTOS(conf-if-gi-9/0)#ipv6 access-group AclList1 in implicit-permit vlan 10-20 FTOS(conf-if-gi-9/0)#show config ! interface GigabitEthernet 9/0 no ip address ipv6 access-group AclList1 in implicit-permit Vlan 10-20 no shutdown FTOSconf-if-gi-9/0)# ipv6 access-list s S6000 Configure an access list based on IPv6 addresses or protocols. Syntax ipv6 access-list access-list-name To delete an access list, use the no ipv6 access-list access-list-name command. Parameters access-list-name Enter the as the access list name as a string, up to 140 characters. Defaults All access lists contain an implicit "deny any"; that is, if no match occurs, the packet is dropped. Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.7.0 Introduced on the S6000. Introduced on the S4810. Usage The number of entries allowed per ACL is hardware-dependent. Refer to your stack-unit Information documentation for detailed specification on entries allowed per ACL. Related Commands show config View the current configuration. ipv6 control-plane egress-filter s S6000 Enable egress Layer 3 ACL lookup for IPv6 CPU traffic. Syntax ipv6 control-plane egress-filter Defaults Not enabled Command Modes EXEC Privilege Access Control Lists (ACL) | 163