Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 277

Table 9-9. Command Example fields: show ip bgp neighbors Lines beginning with Received messages Sent messages Received updates Soft reconfiguration Minimum time (list of inbound and outbound policies) For address family: BGP table version accepted prefixes Prefix advertised Connections established Last reset Local host: Foreign host: Description This line displays the number of BGP messages received, the number of notifications (error messages) and the number of messages waiting in a queue for processing. The line displays the number of BGP messages sent, the number of notifications (error messages) and the number of messages waiting in a queue for processing. This line displays the number of BGP updates received and sent. This line indicates that soft reconfiguration inbound is configured. Displays the minimum time, in seconds, between advertisements. Displays the policy commands configured and the names of the Route map, AS-PATH ACL or Prefix list configured for the policy. Displays IPv4 Unicast as the address family. Displays the which version of the primary BGP routing table the router and the neighbor are using. Displays the number of network prefixes accepted by the router and the amount of memory used to process those prefixes. Displays the number of network prefixes advertised, the number rejected and the number withdrawn from the BGP routing table. Displays the number of TCP connections established and dropped between the two peers to exchange BGP information. Displays the amount of time since the peering session was last reset. Also states if the peer resets the peering session. If the peering session was never reset, the word never is displayed. Displays the peering address of the local router and the TCP port number. Displays the peering address of the neighbor and the TCP port number. Related Commands show ip bgp View the current BGP routing table. show ip bgp next-hop s z S6000 View all next hops (via learned routes only) with current reachability and flap status. This command only displays one path, even if the next hop is reachable by multiple paths. Syntax show ip bgp next-hop Command Modes EXEC EXEC Privilege Example Figure 9-20. Command Example: show ip bgp next-hop FTOS>show ip bgp next-hop Next-hop Via RefCount Cost Flaps Time Elapsed Border Gateway Protocol | 277