Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 536

www.dell.com | support.dell.com Syntax isis hello padding To return to the default, use the no isis hello padding. Defaults Padding of hello PDUs is enabled (ON). Command Modes INTERFACE Command History Version 9.0.2.0 Version 8.3.7.0 Introduced on the S6000. Introduced on the S4810. Usage Hello PDUs are "padded" only when both the global and interface padding options are ON. Turning Information either one OFF will disable padding for the corresponding interface(s). Related Commands hello padding Turn ON or OFF padding for LAN and point-to-point hello PDUs. isis ipv6 metric S6000 Assign metric to an interface for use with IPv6 information. Syntax isis ipv6 metric default-metric [level-1 | level-2] To return to the default values, enter no ipv6 isis metric [default-metric] [level-1 | level-2] command. Parameters default-metric level-1 level-2 Metric assigned to the link and used to calculate the cost from each other router via the links in the network to other destinations. You can configure this metric for Level 1 or Level 2 routing. Range:0 to 16777215 Default: 10 (OPTIONAL) Enter level-1 to configure the shortest path first (SPF) calculation for Level 1 (intra-area) routing. This is the default. (OPTIONAL) Enter level-2 to configure the SPF calculation for Level 2 (inter-area) routing. Defaults default-metric = 10; level-1 (if not otherwise specified) Command Modes INTERFACE Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.3.7.0 Introduced on the S6000. Introduced on Z9000 Introduced on the S4810. Usage Dell Networking Networks recommends configuring metrics on all interfaces. Without configuring Information this command, the IS-IS metrics are similar to hop-count metrics. 536 |