Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 142

www.dell.com | support.dell.com Standard MAC ACL Commands When an access-list is created without any rule and then applied to an interface, ACL behavior reflects implicit permit. s platforms (except the S4810 system) support Ingress MAC ACLs only. The S6000 and Z9000 support both Ingress and Egress MAC ACLs. The following commands configure standard MAC ACLs: • deny • mac access-list standard • permit • seq Note: See also Commands Common to all ACL Types and Common MAC Access List Commands. deny s z S6000 Configure a filter to drop packets with a the MAC address specified. Syntax deny {any | mac-source-address [mac-source-address-mask]} [count [byte]] To remove this filter, you have two choices: • Use the no seq sequence-number command syntax if you know the filter's sequence number or • Use the no deny {any | mac-source-address mac-source-address-mask} command. Parameters any mac-source-address mac-source-address-mask count byte Enter the keyword any to specify that all traffic is subject to the filter. Enter a MAC address in nn:nn:nn:nn:nn:nn format. (OPTIONAL) Specify which bits in the MAC address must match. If no mask is specified, a mask of 00:00:00:00:00:00 is applied (in other words, the filter allows only MAC addresses that match). (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count bytes processed by the filter. Defaults Not enabled. Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD Command History Version 9.0.2.0 Version 8.3.11.1 Version 9.0.2.0 Introduced on the S6000 Introduced on the Z9000. Support added for S-Series Note: When ACL logging and byte counters are configured simultaneously, byte counters may display an incorrect value. Configure packet counters with logging instead. 142 | Access Control Lists (ACL)