Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 504
Table 21-11., Keyword, Definition
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 504 highlights
www.dell.com | support.dell.com Rcvd: 0 format errors, 0 checksum errors, 0 redirects, 0 unreachable 0 echo, 0 echo reply, 0 mask requests, 0 mask replies, 0 quench 0 parameter, 0 timestamp, 0 info request, 0 other Sent: 0 redirects, 0 unreachable, 0 echo, 0 echo reply 0 mask requests, 0 mask replies, 0 quench, 0 timestamp 0 info reply, 0 time exceeded, 0 parameter problem UDP statistics: Rcvd: 0 total, 0 checksum errors, 0 no port 0 short packets, 0 bad length, 0 no port broadcasts, 0 socket full Sent: 0 total, 0 forwarded broadcasts TCP statistics: Rcvd: 23829 total, 0 checksum errors, 0 no port Sent: 16048 total ARP statistics: Rcvd: 156 requests, 11 replies Sent: 21 requests, 10 replies (0 proxy) Routing Processor1 IP Traffic: Table 21-11. show ip traffic output definitions Keyword unknown protocol... not a gateway... security failures... bad options... Frags: ... reassembled ... timeouts ... too big ... couldn't fragment ...encapsulation failed Rcvd: ...short packets ...bad length ...no port broadcasts ...socket full Definition No receiver for these packets. Counts those packets whose protocol type field is not recognized by FTOS. Packets can not be routed; host/network is unreachable. Counts the number of received unicast/multicast packets that could not be forwarded due to: • route not found for unicast/multicast; ingress interfaces do not belong to the destination multicast group • destination IP address belongs to reserved prefixes; host/network unreachable Unrecognized IP option on a received packet. IP fragments received. Number of IP fragments that were reassembled. Number of times a timer expired on a reassembled queue. Number of invalid IP fragments received. Number of packets that could not be fragmented and forwarded. Counts those packets which could not be forwarded due to ARP resolution failure. FTOS sends an arp request prior to forwarding an IP packet. If a reply is not received, FTOS repeats the request three times. These packets are counted in encapsulation failed. The number of bytes in the packet are too small. The length of the packet was not correct. The incoming broadcast/multicast packet did not have any listener. The applications buffer was full and the incoming packet had to be dropped. 504 | IPv4 Routing