Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 260
router bgp, show capture bgp-pdu neighbor
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 260 highlights
www.dell.com | support.dell.com Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.8.1.0 Version 8.3.1.0 Introduced on the S6000. Introduced on the Z9000. Introduced support on S-Series Introduced ability to substitute IGP cost for MED when a peer/peer-group outbound route-map is set as internal. router bgp s z S6000 Enter ROUTER BGP mode to configure and enable BGP. Syntax router bgp as-number To disable BGP, use the no router bgp as-number command. Parameters as-number Enter the AS number. Range: 1 to 65535 (2-Byte) or 1-4294967295 (4-Byte) or 0.1-65535.65535 (Dotted format) Defaults Not enabled. Command Modes CONFIGURATION Example Command History Figure 9-3. Command Example: router bgp FTOS(conf)#router bgp 3 FTOS(conf-router_bgp)# Version 9.0.2.0 Version 8.3.11.1 Version 7.8.1.0 Introduced on the S6000. Introduced on the Z9000. Introduced support on S-Series Usage Information At least one interface must be in Layer 3 mode for the router bgp command to be accepted. If no interfaces are enabled for Layer 3, an error message appears: % Error: No router id configured. show capture bgp-pdu neighbor s z S6000 Display BGP packet capture information for an IPv4 address on the system. Syntax show capture bgp-pdu neighbor ipv4-address Parameters ipv4-address Enter the IPv4 address (in dotted decimal format) of the BGP address to display packet information for that address. Command Modes EXEC Privilege Example Figure 9-4. Command Example: show capture bgp-pdu neighbor FTOS(conf-router_bgp)#show capture bgp-pdu neighbor 20.20.20.2 260 | Border Gateway Protocol