Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 826
debug radius, ip radius source-interface
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 826 highlights
www.dell.com | support.dell.com debug radius z S6000 View RADIUS transactions to assist with troubleshooting. Syntax debug radius To disable debugging of RADIUS, enter no debug radius. Defaults Disabled. Command Modes EXEC Privilege Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000 ip radius source-interface z S6000 Specify an interface's IP address as the source IP address for RADIUS connections. Syntax ip radius source-interface interface To delete a source interface, enter no ip radius source-interface. Parameters interface Enter the following keywords and slot/port or number information: • For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For Loopback interfaces, enter the keyword loopback followed by a number from zero (0) to 16838. • For the Null interface, enter the keywords null 0. • For the Port Channel interface, enter the keyword port-channel followed by a number: S-Series Range: 1-128 • For a Ten Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. Defaults Not configured. Command Mode CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000 826 | Security