Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 706

www.dell.com | support.dell.com description z S6000 Enter a description of this monitoring session Syntax description {description} To remove the description, use the no description {description} command. Parameters description Enter a description regarding this session(80 characters maximum). Defaults No default behavior or values Command Modes MONITOR SESSION (conf-mon-sess-session-ID) Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000 Related Commands monitor session Enable a monitoring session. monitor session z S6000 Create a session for monitoring traffic. Syntax monitor session session-ID To delete a session, use the no monitor session session-ID command. To delete all monitor sessions, use the no monitor session command. Parameters session-ID Enter a session identification number. Range: 0 to 65535 Defaults No default values or behaviors Command Modes MONITOR SESSION (conf-mon-sess-session-ID) Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000 Example Usage Information Figure 32-1. Command Example: monitor session FTOS(conf)# monitor session 60 FTOS(conf-mon-sess-60) All monitor sessions contain an implicit "mode interface," that is, if no mode is designated, the mode is set to interface as shown in the example above. The monitor command is saved in the running configuration at the Monitor Session mode level and can be restored after a chassis reload. 706 | Port Monitoring