Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 466
In the event of fragmented packets, egress port of the first fragment.
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 466 highlights
www.dell.com | support.dell.com source-ip address destination-ip address protocol number | tcp | udp source-port number destination-port number source-mac address destination-mac address Enter the keyword source-ip followed by the IP source address in IP address format. Enter the keyword destination-ip followed by the IP destination address in IP address format. Fnter the keyword protocol followed by one of the protocol type keywords: tcp, udp or protocol number Enter the keyword source-port followed by the source port number. Range: 1-65536 Default: None Enter the keyword destination-port followed by the destination port number. Range: 1-65536 Default: None Enter the keyword source-mac followed by the MAC source address in the nn:nn:nn:nn:nn:nn format. Enter the keyword destination-mac followed by the MAC destination address in the nn:nn:nn:nn:nn:nn format. Command Modes EXEC Usage Information Since this command calculates based on a Layer 2 hash algorithm, use this command to display flows for switched Layer 2 packets, not for routed packets (use the show ip flow command to display routed packets). The show port-channel-flow command returns the egress port identification in a given port-channel, if a valid flow is entered. A mismatched flow error occurs if MAC-based hashing is configured for a Layer 2 interface and the user is trying to display a Layer 3 flow. The output will display three entries: • Egress port for unfragmented packets. • In the event of fragmented packets, egress port of the first fragment. • In the event of fragmented packets, egress port of the subsequent fragments. Example show port-channel-flow port-channel number incoming-interface interface-type slot/port src-mac MAC-Address dest-mac MAC-Address vlan/ether-type Vlan-Number/ether-type src-ip IP-Address dest-ip IP-Address protocol tcp/udp/protocol number src-port Port dest-port Port • Load-balance is configured for MAC • Load balance is configured for IP 6-tuple/2-tuple for the S-Series • A non-IP payload is going out of Layer 2 LAG interface that is a member of VLAN with an IP address. Figure 20-40. show port-channel-flow Command for MAC Addresses FTOS#show port-channel-flow port-channel 1 incoming-interface gi 3/0 source-mac 00:00:50:00:00:00 destination-mac 00:00:a0:00:00:00 Egress Port for port-channel 1, for the given flow, is Te 13/01 466 | Interfaces