Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 447

Table 20-7. show interfaces description Command Example Fields Field Description Interface Displays type of interface and associated slot and port number. OK? Indicates if the hardware is functioning properly. Status States whether the interface is enabled (up) or disabled (administratively down). Protocol States whether IP is enabled (up) or disabled (down) on the interface. Description Displays the description (if any) manually configured for the interface. Related Commands show interfaces Display information on a specific physical interface or virtual interface. show interfaces stack-unit s z S6000 Display information on all interfaces on a specific stack member. Syntax show interfaces stack-unit unit-number Parameters unit-number Enter the stack member number Unit ID range: S4810: 0-11 Z9000: 0-7 S6000: 0-5 Command Modes EXEC EXEC Privilege Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.3.7.0 Introduced on the S6000. Introduced on Z9000 Introduced on the S4810. Example Figure 20-31. show interfaces status Command Example FTOS#show interfaces stack-unit 0 GigabitEthernet 0/1 is down, line protocol is down Hardware is FTOSEth, address is 00:01:e8:4c:f2:82 Current address is 00:01:e8:4c:f2:82 Pluggable media not present Interface index is 34129154 Internet address is not set MTU 1554 bytes, IP MTU 1500 bytes LineSpeed auto, Mode auto ARP type: ARPA, ARP Timeout 04:00:00 Last clearing of "show interface" counters 3w0d17h Queueing strategy: fifo Input Statistics: 0 packets, 0 bytes 5144 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 0 Multicasts, 0 Broadcasts Interfaces | 447