Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 408
show ip igmp ssm-map
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 408 highlights
www.dell.com | support.dell.com Usage Information IGMP commands accept only non-VLAN interfaces-specifying VLAN will not yield a results. Note: The S4810 supports up to 95 interfaces. Example Figure 19-2. show ip igmp interface Command Example FTOS#show ip igmp interface GigabitEthernet 0/0 is down, line protocol is down Internet protocol processing disabled GigabitEthernet 0/5 is down, line protocol is down Internet protocol processing disabled GigabitEthernet 0/6 is down, line protocol is down Internet protocol processing disabled GigabitEthernet 0/7 is up, line protocol is down Internet protocol processing disabled GigabitEthernet 7/9 is up, line protocol is up Internet address is 10.87.5.250/24 IGMP is enabled on interface IGMP query interval is 60 seconds IGMP querier timeout is 120 seconds IGMP max query response time is 10 seconds IGMP last member query response interval is 1000 ms IGMP activity: 0 joins, 0 leaves IGMP querying router is 10.87.5.250 (this system) IGMP version is 2# show ip igmp ssm-map z S6000 Display is a list of groups that are currently in the IGMP group table and contain SSM mapped sources. Syntax show ip igmp ssm-map [group] Parameters group (OPTIONAL) Enter the multicast group address in the form A.B.C.D to display the list of sources to which this group is mapped. Command Modes EXEC EXEC Privilege Command History Related Commands Version 9.0.2.0 Version 8.3.11.1 Introduced on then S6000. Introduced on the Z9000. ip igmp ssm-map Use a statically configured list to translate (*,G) memberships to (S,G) memberships. 408 | Internet Group Management Protocol (IGMP)