Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 545
passive-interface
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 545 highlights
Defaults Disabled Command Mode CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 Command History Version 9.0.2.0 Version 8.3.7.0 Introduced on the S6000. Introduced on the S4810. net S6000 Use this mandatory command to configure an IS-IS network entity title (NET) for a routing process. If a NET is not configured, the IS-IS process will not start. Syntax net network-entity-title To remove a net, enter no net network-entity-title. Parameters network-entity-title Specify the area address and system ID for an IS-IS routing process. The first 1 to 13 bytes identify the area address. The next 6 bytes identify the system ID. The last 1 byte is the selector byte, always identified as zero zero (00). This argument can be applied to an address or a name. Defaults Not configured. Command Modes ROUTER ISIS Command History Version 9.0.2.0 Version 8.3.7.0 Introduced on the S6000. Introduced on the S4810. passive-interface S6000 Suppress routing updates on an interface. This command stops the router from sending updates on that interface. Syntax passive-interface interface To delete a passive interface configuration, enter the no passive-interface interface command. Parameters interface Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For Loopback interface, enter the keyword loopback followed by a number from zero (0) to 16383. • For a Port Channel interface, enter the keyword port-channel followed by a number from 1 to 32 for EtherScale, 1 to 255 for TeraScale. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Defaults Not configured. | 545