Brother International PDP350CJ Owner's Manual - English - Page 380

APPENDIX Troubleshooting 09o2536 "This document has not been saved. Please save it now." message appears. "Document is too big. Please break it up into smaller documents." message appears. "Please close one document." message appears. I cannot find the document I am looking for. A disk could not be found. Cursor will not move where I want it to go. My document is printed in the wrong direction on the paper. I put a diskette in the disk drive, but Ensemble cannot find it. The lines or objects I draw do not go where I want them to go. Lines and specks appear on the screen. I made a mistake and I want to undo it. I cannot find my cursor. Part of the image on the screen is missing. The tones on the screen are not the tones I selected. I cannot select text in the Drawing application. 0oAA4253 1o5Ct4on You have not named and saved your document. The size of this document is greater than 20k. Save it and continue working. The size of your document is greater than or equal to 100K (approximately 20 pages of text). Save this document to diskette and begin another document at this point. If you choose not to save and Ensemble runs out of memory, you could lose all your work. The size of the two documents you have open is greater than or equal to 100K (approximately 20 pages of text). Save one or both documents to a diskette and begin another document at this point. If you choose not to save and Ensemble runs out of memory, you could lose all your work. Make sure that you have opened the correct application. The list of documents shows only documents created in the application you are using. For example, Word Processing documents do not show up in the Text File Editor. Your document may be down in the scrolling list where you cannot see it. Use the scroll bar to see more of the list. Your document may be on a different diskette. Insert a diskette. To move the cursor with the mouse to a certain place, you must have text in that area. Press ENTER to move the cursor down the page. Make sure your settings in both Page Set Up and Page Size are the same as your Printer Options. Rescan the diskette from the Disk menu. Turn off Snap to Grid. In Word Processing, select Grids under the Layout menu. In Drawing, select Grids from the Options menu. Click on the Redraw Screen icon on the far right-hand side of the Basic Functions tool bar in Word Processing. Choose Undo from the Edit menu. See page 83. Check to see that you have a text tool selected. Click on the Redraw button on the far right-hand side of the tool bar. Make sure you are in Normal drawing mode. Convert the text from Graphic. Appendix 353