Sony XVS-7000 Users Guide - Page 102
Executing an independent key transition, key fader control block
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
KEY5 ON to KEY8 ON buttons Independent key transition display section When the Keyframe Strobe effect is set, the effects are equivalent to operation using keyframes. In this case as well, cancel the unnecessary DME settings. Executing an independent key transition (key fader control block) Independent key transition type selection buttons Key delegation buttons KEY1 ON to KEY4 ON buttons AUTO TRANS button Transition control block 1 Set the independent key transition type. The independent key transition type is set using the menu (see page 103) or Flexi Pad control block (see page 103). 2 Set the independent key transition rate. The independent key transition rate is set using the menu (see page 104), or utility/shotbox control block and numeric keypad control block (see page 104). 3 Execute the independent key transition on the transition control block or independent key transition control block. To insert or remove the key gradually with a mix or wipe, press the [AUTO TRANS] button. This executes the transition at the preset transition type and transition rate. To insert/remove the key instantaneously, press the [KEY1 ON] to [KEY8 ON] buttons (or the [KEY ON] button for the corresponding key). Notes • In an independent key transition, the pattern limit function is not available. • When the following DME effects are set, the DME effects may be applied during wipe transitions. If the effects are not necessary, cancel the DME settings. - Trail - Motion Decay - Wind Fader lever KEY ON buttons AUTO TRANS buttons Key fader control block 1 Select the target key to operate using the key delegation buttons. 2 Set the transition type using the independent key transition type selection buttons. Press the [MIX], [WIPE], [DME WIPE], or [CUT] button, turning it on. When [Independ] is selected in the group of the Engineering Setup >Switcher >Transition menu (7334), you can set the transition type used when inserting and removing a key. If the transition type used when inserting a key is displayed, you can select the transition type used when removing a key by pressing and holding the [SHIFT] button and pressing an independent key transition type selection button. If the transition type used when removing a key is displayed, you can select the transition type used when inserting a key using the same operation. You can check the specified independent key transition type on the display (see page 103). 3 Set the independent key transition rate. The independent key transition rate is set using the menu (see page 104), or utility/shotbox control block and numeric keypad control block (see page 104). 4 Execute the independent key transition. 102